Images/schemes proposed are to be considered as indicative and non-binding

Z-KEY-2ETH EtherNet/IP (HW rev. C0)

2-port EtherNet/IP -> ModBUS RTU/ASCII/TCP-IP gateway & protocol converter, dual Ethernet

SENECA offers three Ethernet/IP gateway variants that differ in form factor and number of Ethernet ports. The Z-KEY-2ETH Ethernet/IP model is designed to simplify network communications between Modbus RTU/ASCII/TCP devices and EtherNet/IP networks. This gateway takes on the main function of acting as a Modbus master to acquire and exchange data with EtherNet/IP devices. Concretely, the R-KEY-LT converts Modbus data into EtherNet/IP packets, enabling an EtherNet/IP scanner to control or monitor Modbus devices. In detail, the Ethernet/IP gateway works as ModBUS Master devices on the serial side and Ethernet/IP adapters on the Ethernet side. Modbus requests, such as read or write commands, are configured directly on the devices, automatically generating an EDS file. Once this file is imported into the PLC development software, e.g. Rockwell STUDIO 5000, all configured I/O will be accessible without further configuration. In addition, up to 3 Modbus TCP-IP servers can be connected in addition to the serial devices.

205,00 €

: 194,75 €

TECHNICAL DATA

Power supply	10..40 Vdc; 19..28 Vac
Absorption	Max 2 W
LED Status Indicators	Power supply Rx/Tx RS232/RS485 port Rx/Tx RS485 port Transmission/Ethernet connection Ethernet/IP communication
Isolation	1.5 kVac (4-way)
Grade of Protection	IP20
Operating temperature	-25..+65°C
Connections	3-way removable screw terminals, 5 mm pitch Rear IDC10 connector for DIN rail 46277 2x Front RJ45 connector
Ethernet Ports	No.2 Fast Ethernet ports 100 Tx, RJ45 front
Serial Ports	Nr.1 RS232 / RS485 switchable port, max 115k baud rate on connector Nr.1 RS485 port, max 115k baud rate on IDC10 connector for bus and terminals
Supported protocols	ModBUS RTU, ModBUS TCP-IP, ModBUS ASCII
Operating mode	ModBUS RTU/TCP-IP/ASCII -> Ethernet/IP Gateway
Dedicated Memory Area for commands	512 Bytes R/W
Max client TCP-IP (Server Mode)	3
Max ModBUS RTU/ASCII slave nodes	128
Dimension (wxhxd)	17.5 x 100 x 112 mm
Weight	100 g
Case	Nylon 6 com 30% glass fiber, self-extinguishing class V0
Installation	For DIN rail (IEC EN 60715)
Certifications	CE, UKCA
CONFIGURATION
DIP Switch	Flash memory, IP address, serial activation
Web Server	Ethernet/IP parameters, ModBUS registers, firmware update, serial traffic, I/O mapping, EDS export
Configuration File	EDS
SDD (Seneca Discovery Device)	x