Images/schemes proposed are to be considered as indicative and non-binding

K111D

K111D, K111D-C

Divider and frequency repeater with two isolated outputs

K111D is a frequency divider (capable of handling up to 256 pulses at the input) with the function of an input signal repeater. It has an isolated and stabilized power supply unit and front LED for power supply and outputs status. The galvanic isolation for signals originating from On/Off sensors is 1,500 V. The module accepts various types of input signals, with frequency up to 20 kHz, selectable for 2/3-wires sensors: NPN 12/24V, PNP, PNP 12/24V, photoelectric pulse, contact IEC 1131-1, Namur, Reed.
The 2 independent outputs are PNP high current outputs (up to 200 mA) with internal short-circuit protection. They can also be configured in divider or repeater mode. The module can be configured via PC using the S117P1 converter or via DIP switch.

99,00 €

: 94,05 €

TECHNICAL DATA

Power supply	19,2..30 Vdc (direct) or with Smart Supply system
Power supply on side clamps	Yes
Sensor power supply	Yes, available voltages 8V±0.6V, 12±1V, 22V±2V, max. current 22 mA
Hot swapping	Yes
Max absorbed current	< 25 mA
Max. power dissipation	500 mW
Conversion A/D	14 bit
Rejection	50 - 60 Hz
LED	Power supply, outputs status
Configuration	via Software (EASY SETUP), via DIP switch
Input filter	Can be activated with programmable cut-off frequency
Insulation	1,5 kVac (2 ways, input // output)
Insulation technique	Digital / Optocoupler
Elaboration	32-bit floating point calculation
Communication port	1 4pin frontal connector, pitch 2,54 mm
Accuracy class	0,1%
Special functions	Direct operation Repeater Frequency divider Average measurement in a window of N pulses (N<=256)
Connection	Spring and/or Bus
Input channel	1
Input type	Mechanical contact, contact IEC 1131.2 (type 1), Namur (DIN 19234, EN 60947-5-6), 2-wire NPN / PNP (12 or 22 V), Reed, Photocell, Reed
Output channels	2 independent channels protected by DC
Output types	independent channels protected against DC, PNP, Repeater or Input Divider
Housing	PBT, black
Protection degree	IP20
Dimension WxHxD	6,2x93,1x102,5 mm
Weight	45 g
Operating temperature	-20..+65°C
Mounting	Guida DIN 35 mm IEC EN60175