Release Notes Firmware SW01240-3.1.6.0

======================================
Supported Products:
R-PASS (A0)
SSD (B0)
Z-PASS2-RT-4G (A0)
Z-PASS2-RT-4G (B0)
Z-PASS2-RT-4G (C0)
Z-PASS2-RT-4G-S (A0)
Z-PASS2-RT-4G-S (B0)
Z-PASS2-RT-4G-S (C0)
Z-TWS4-RT-S (A0)
Z-TWS4-RT-S (B0)
Z-TWS4-RT-S (C0)
Z-PASS1-RT (A0)
Z-PASS1-RT (B0)
Z-PASS1-RT (C0)

======================================

ATTENTION! Inside the compressed file there are two different .BIN files. Please check the firmware version of the device to be updated and use the correct “.bin” file:
- SW012400_chm.bin = to update a device that uses firmware FW01240-x.x.x.x
- SW01978_xxxx.bin = to update a device that uses firmware FW01978-y.y.y.y
If in doubt, contact the support team via email support@seneca.it

WARNING! after resetting to factory settings, Straton PORT is 1100 (no longer 502)

NEW:
- Data Logger: “Group Configuration” page: possibility to select the protocols to be associated with each sampling group has been introduced
- Logical Rules: new types for the “Schedule” condition have been added:
- “Every Year”
- “Every Hour”
- ‘Every N Minutes”
- error counters with the relative embedded tags have been added

FIX:
- Data Logger: ’General Settings” page: the parameters “Send Data Logs via HTTP POST” and “HTTP POST Tag Limitation” have been eliminated
because they were a duplication of the parameters “Enable” and “Seneca protocol” in “HTTP Configuration”
- “Conf. Management” page: fixed the problem where saving the configuration (“All” and “Config”) failed when the SFTP/SSH server was not enabled (factory default)
- “Conf. Management” page: the “RESET” button in the “Load SSH Key” section now restores the default key instead of completely deleting the key file
- MQTT: fixed problem where writing a tag with a name longer than 20 characters failed
- VPN Box 2: management of NAT rule between VPN and LAN with variable netmask (no longer fixed at “/24”)