Firmware Release Notes SW01978-3.1.1

Supported devices:
Z-PASS2-RT-4G (A0)
Z-PASS2-RT-4G (B0)
Z-PASS2-RT-4G-S (A0)
Z-PASS2-RT-4G-S (B0)
Z-PASS1-RT (A0)
Z-PASS1-RT (B0)
Z-TWS4-RT-S (A0)
Z-TWS4-RT-S (B0)
R-PASS (A0)
SSD (B0)

WARNING. There are two different .BIN files within the compressed file. We encourage you to check the firmware in the device to be upgraded and use the correct ".bin" file:
- SW012400_chm.bin = to update a device using firmware FW01240-x.x.x.x
- SW01978_xxxx.bin = to update a device using firmware FW01978-y.y.y.y
If in doubt, contact the support team by email support@seneca.it

WARNING! after reset to factory values the Straton PORT number is 1100 (no longer 502)


NEW:
- added new management code ‘SMART-DISPLAY-S’ (SDS-1)
- added user-selected image display on screensaver in GUI (SMRTDISP-43)
- Managed new revision Z-PASS HW rev ‘C0’
- Minorfix for ‘Cyber Security’.
- Introduced OPC-UA CLIENT PLC version
- Shared function introduced 

FIX:
- Disabled the ‘Cloud Configuration’ link if the licence does not contain the ‘IOT’ option
- GUI:
- added ‘$’ character and other special characters in the virtual keyboard
- SETUP/SERIAL PORTS: management of the ‘RS232/Z-MBUS’ value of the ‘COM1 Mode’ parameter, with ‘PLC Mode’="Shared’
- Fix SETUP/TAGS: disabling of the option RETAIN=ON, when in the ‘PLC Configuration’ ‘Retain Variables Enable’=ON, with ‘PLC Mode’="Shared’
- handling of the case where there is no exported tag for the GUI
- Fix page ‘Tag Setup’: fixed error where, with ‘PLC Mode’=None, it was no longer possible to configure a tag with RETAIN=ON
- Fix page ‘Cloud Configuration’: changes to allow the fields ‘Username for Commands’, ‘Password for Commands’ with ‘Cloud Type’=‘Direl-ADM’ to be left empty
- Fix page ‘FTP Configuration’: changes to allow the characters ‘.’ and ‘-’ in the parameter ‘Path’
- Fix page ‘Tag Setup’ (MODIFY): modification to handle the situation where the ‘RETAIN’ parameter of the tag is ‘ON’, but the value ‘ON’ does not appear among the possible options
- Fix WiFi: Modification to allow setting an SSID containing the ‘$’ character